Hi everyone! I’m fortunate that the CB-6000 paired with a KSD-G3 feels very secure for me. I know many others struggle with security using these devices, so I consider myself lucky. That said, even in its modified state, I don’t care much for the KSD-G3 because it restricts blood flow and reduces comfort somewhat—but we trade off comfort to gain security. I decided to craft a belt, and I’m pleasantly surprised by how easy and inexpensive it was. I’m happy to share that I no longer need to wear the KSD-G3 since this homemade belt completely eliminates pullout issues for me. I picked up some wire at Home Depot; it’s covered in clear plastic (which is hard to see in the photos), but the material is smooth and non-abrasive. Attaching it to the device was simple, with only one minor downside: the connection point can occasionally pinch slightly, though I don’t find it bothersome. When worn tightly, the belt pulls the entire unit inward so firmly that I can barely fit my pinky finger under the top edge, effectively ruling out any pullout risk. The small catch is that because it attaches to the top and is tight, it tugs the device upward a bit. However, since I’ve been wearing panties for years, putting them on pulls the unit back down into place while keeping everything discreet under clothes. You’ll definitely want snug underwear or panties; without them, there’s more of a visible bulge when clothed. I’ve worn this belt for six days now and have been quite comfortable—whether standing, lying down, or walking long distances. There are no skin issues or irritation to report. Again, the only slight annoyance is occasional minor pinching where the belt connects to the device, but it’s really negligible. The total cost was around $10 (I bought extra wire), so I have enough materials to make another one if needed, along with surplus connectors for the loops in the wire. You could probably do this project for about $5 easily. It took me roughly 10 minutes from start to finish, including measuring. I hope this is useful for others who have experienced security concerns with the CB-X000 series devices. I find it to be the most comfortable and visually pleasing ball-trapper device available. My wife and I personally dislike the appearance of full steel belts, so this DIY option offers a perfect balance of security and comfort for us—I’m thrilled!
Please feel free to reach out if you need any assistance or have your own improvements to suggest! I’ll be posting some photos of myself wearing it soon as well.